MakerWorld
Engineering
Go to Model
Magnetic 3D Marker Scanning Tracker Dot
306
Downloads
84
Likes
128
Makes
A 3D Marker dot to be used with a 3D Scanner. Easy mounting on magnetic surfaces/flat surfaces. Reduces waste/cost of always disposing of markers after a single use.Most materials will work fine, I would recommend the support on the underside but if you are confident in your overhands you may be fine without. I added a little chamfer to the bottom so it's easy to remove. The small magnets give you a good hold without being impossible to take off or move. I also have other shapes on my page. Here is the collection of other marker types:https://makerworld.com/en/collections/2698008 Boost MeIf this helped I would appreciate a boost! Thanks:) What you need besides the print (per dot):1x 10x6mm Reflective Markers (example 1000pcs from Aliexpress)1x 4x1mm Diameter Magnet (got a bunch for cheap from Aliexpress)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
