MakerWorld
Gadgets
Zum Modell
Magnetic Badge holder
0
Downloads
0
Likes
0
Makes
Magnetic badge holder This magnetic badge holder prints in place with no supports and uses 20x5x2 magnets on the holder and the backing clip (expect a tight fit). Transparent Bambu Lab PETG with honeycomb infill was used to print the holder as seen in the attached photos.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
