MakerWorld
Other Tools
Go to Model
Magnetic Bit Driver
8
Downloads
9
Likes
0
Makes
Printed at 0.2mm layer height, 4 walls.I inserted a print pause at 4mm height for the magnet placement. The magnets I have are a tight fit and require an even press fit.The version with ribs may be a very tight fit depending on your bit(s). This was intentional to avoid loose bits. If you find the fit too tight, use the version without ribs. If you get a bit stuck, pliers should be able to solve the problem!
vidision also publishes on
464 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
