Magnetic Build Plate Alignment Handle

Update 05.03.25: I uploaded a magnetic holder for IKEA Skadis pegboards.You can check it out HERE Holder needs another 3 (or at least 1) 10x2mm magnets Introduction:Since I couldn't find any quick, easy and safe tools to align the build plate properly onto the bed on MakerWorld, which suit my safety concerns about scratching any surface or possibly cause collisions, I designed this simple handle for my A1. I designed this handle for 10x2mm magnets, with a 2,2mm deep pocket, to make sure the magnets don't scratch the surface of the build plate while still being strong enough to hold it. Therefore you will need: 3pcs of 10x2mm magnetsa tiny bit of glue Please make sure the magnets are actually close to 2mm thick, otherwise either the surface of the plates may get scratched or the magnetic strength might be too low. Note: This handle doesn't necessarily require magnets, but I highly recommend it for easier usage and better alignment. Quick summary:The handle works for all buil