Magnetic cable guide

Magnetic/screw clamp/holder/guide for wires/cables etc for light weight application- Attach using magnets or screw- Fits a magnet of 6mm diameter and 3mm height- Three different magnet tolerances (print profiles): - v2 0.05mm. Snug fit (Recommended) - v3 0.1mm. Just fits (Might need to be glued down) - Three different sizes (Plates). - Enable brim if you have bed adhesion issues.TinyThe overall diameter is about 12mmFits a cable/wire etc of ~4mmFilament usage: 1.32gPrint time: 15mins on P1S SmallThe overall diameter is about 12mmFits a cable/wire etc of ~4mmFilament usage: 1.64gPrint time: 18mins on P1S LargeThe overall diameter is about 14mmFits a cable/wire etc of ~7mmFilament usage: 2gPrint time: 18mins on P1S