Thingiverse
Magnetic Cable Holder
par 3Dsection
116
Téléchargements
115
Likes
0
Makes
This is a cable holder with 2 magnets inside.
The diameter of the magnets is 8mm with a hight of 1mm.
You have to put one magnet inside the mount and glue it from the back to a surface.
Then from the front you can see no magnet - only through the 0.2mm thin PLA cover layer.
The other two pieces you have to put around a 4mm cable.
Use a little bit of glue between the "ZicZac" area to fix it permanently.
Oh, and don´t forget to glue on the second magnet ;)
Have fun :)
The diameter of the magnets is 8mm with a hight of 1mm.
You have to put one magnet inside the mount and glue it from the back to a surface.
Then from the front you can see no magnet - only through the 0.2mm thin PLA cover layer.
The other two pieces you have to put around a 4mm cable.
Use a little bit of glue between the "ZicZac" area to fix it permanently.
Oh, and don´t forget to glue on the second magnet ;)
Have fun :)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
