Thingiverse
Magnetic Case for Squashballs
door jomivo
1
Downloads
2
Likes
0
Makes
This is a magnetic box for three squash balls. The magnets are embedded in the print so you have to configure a pause at Z in your slicer.
You'll need additionally:
- 8x3 mm Magnets (6 pieces)
Make sure you've checked the polarity before printing and that they are all aligned. So dont just make pairs, make sure that e.g. all norths are facing up so that the case will close at any position.
You'll need additionally:
- 8x3 mm Magnets (6 pieces)
Make sure you've checked the polarity before printing and that they are all aligned. So dont just make pairs, make sure that e.g. all norths are facing up so that the case will close at any position.
jomivo publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
