Magnetic Dart

This is a magnetic dart. A normal whiteboard with any drawing on it can be used as a target.
You need to print the paper tail on a "normal" printer, cut it to be square, fold it and insert it in the dart body. (You can create any tail you like).
Further you need a round magnet 10 mm and 5 mm height. You can buy those in the internet (i.e. supermagnets.ch).
Also cut a 2 cm disc with a 1 cm hole to glue around the magnet. This is for shock absorption I used a 3 mm isolation foam.

For the tail-fin: there is a .pdf file as an example.
Print out this file borderless preferably on A4 format (American format should not make much of a difference)

After printing cut the paper to become square.
Fold the ends along the horizontal line up (Valley fold)
Fold back turn 90 degrees and fold the ends according the vertical line up (Valley fold)

Turn the paper over and fold the paper according to the dotted diagonal lines (mountain fold)
Repeat for the other diagonal

Than form the f