Magnetic Door Stop Spring-Loaded

A simple device to hold your door open, with magnets for ease of use. One part attaches to your wall and is spring loaded, so you can close the door with a little force, without worrying about anything breaking. The other part attaches to your door, I advise either at the top or bottom, to stay discrete. It prints easily, with no supports, and no hassle. The assembly is very simple, with everything but the magnets screwing together. Boost MeI am saving to invest in a new printer, so a Boost or two would be very appreciated!!! It helps me to continue my experiments, and to continue developing new designs. It takes many trial runs, and lots of filament to design new models. Assembly:First, assemble the half that goes on the wall. To do this, screw the button into the spring, then slide it into the body. Then screw on the bottom. Second, glue two 12X3 mm magnets into the two spots on the two halves, with a glue that will hold them well. Third, Apply the sticky tape to the bottoms of them