Thingiverse
Magnetic Elevated Gaming Surface Legs
von levenimc
37
Downloads
22
Likes
0
Makes
I wanted an elevated gaming surface, but didn't want to pay the crazy prices folks are charging for them, so I made my own.
I bought 2'x3' magnetic whiteboard from Target, removed the frame, added one of my battlemats to the surface, reattached the frame, and put legs on the bottom. This Thing™ is for the leg holders and end-caps.
I also designed full legs, both in 130mm (roughly 5") and 100mm (roughly 4") heights.
I wanted removable legs, so I ended up using a 1/4" x 48" weldable steel rod from Menards, cutting it into sections with an angle grinder, clamping them all together, grinding them to the same length, and rounding the edges with my bench grinder. I then printed the leg holders and end-caps out of TPU and assembled. The leg holders are simply applied to the back of the whiteboard with CA glue. I thought about going with 6 legs (two in the middle, in line with the other corner legs) but this arrangement of 5 was plenty, and I was able to create a 4" and a 5" set of l
I bought 2'x3' magnetic whiteboard from Target, removed the frame, added one of my battlemats to the surface, reattached the frame, and put legs on the bottom. This Thing™ is for the leg holders and end-caps.
I also designed full legs, both in 130mm (roughly 5") and 100mm (roughly 4") heights.
I wanted removable legs, so I ended up using a 1/4" x 48" weldable steel rod from Menards, cutting it into sections with an angle grinder, clamping them all together, grinding them to the same length, and rounding the edges with my bench grinder. I then printed the leg holders and end-caps out of TPU and assembled. The leg holders are simply applied to the back of the whiteboard with CA glue. I thought about going with 6 legs (two in the middle, in line with the other corner legs) but this arrangement of 5 was plenty, and I was able to create a 4" and a 5" set of l
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
