Magnetic Flexible Cable Management Arc

I was inspired by the LTT cable management arches (not yet released at the time, but featured on WAN Show), and wanted to see if I could design a more flexible solution, both in terms of sizing and literary.You will need:2x 15*3 Magnets per unit. That's the same size as for my other cable management solution.Some glue, preferably the kind that dries very quickly.Printing:I tested up to a 0.3mm layer height and a 0.6 nozzle and it worked perfectly, no need to go with a smaller layer height.PLA is recommended to minimize warping and lifting of the corners - there are a lot of small parts here that the nozzle could easily knock loose.Z-hop should be on for the same reason.Make sure the bed is clean (same reason).If the nozzle is still knocking stuff off the bed — slow down the print to 75–50%.Post-PrintingRemove the model from the build plate.Put a drop of glue in both magnet holes. Don't use too much glue, or it will splash out or glue your finger to the magnet.Insert the magnets