Magnetic Lamp

Designed in Blender and printed out using Ender 3 max,
two designs are very similar in concept, one is just a bit more curvy in the base.

the connection diagrams are attached, electrical cables for the LED strip (blue & Black) shall pass through the wide opening while the circuit breaker transparent string shall pass through the small one, (Green)
(blue) line is a metal needle that is glued in place, (red) line ends by a wire or needle to the (blue) line side, it should be couple of millimeters vertically apart from (blue). the red wire is then tied to the transparent string that is passing through the opening (Green).
When magnets are close to each other, the string (green) shall pull the (Red) wire to make contact with the (Blue) wire to close the circuit

The setup used is 12V DC convertor connected to 12DC RBG LED strip that is cut to size, other LED strips can be used as well.
Magnets are cylindrical with 8mm diameter and 3 mm thickness, other magnets sizes can be used by