Thingiverse
Magnetic Levitation Module Case
door JoshuaMcGraw
10
Downloads
10
Likes
0
Makes
This fits a Magnetic Levitation Module.
*As of uploading this design, this is the module I used:*
(As with many suppliers, it's uncertain how long any source will be available, but most designs are going to be along the same specifications.)
- *Printing:*
Print with support for the DC power hole.
Any layer height, any infill.
- *Assembly:*
The threads are very small and probably won't hold. I used a soldering iron to carefully heat a screw and seat it inside the plastic.
Place the module power wire along the groove first, then insert the module.
There is a 0.3mm tolerance between the base pegs and the case insert. This is to account for both printed sides, so it may be a tight fit.
*As of uploading this design, this is the module I used:*
(As with many suppliers, it's uncertain how long any source will be available, but most designs are going to be along the same specifications.)
- *Printing:*
Print with support for the DC power hole.
Any layer height, any infill.
- *Assembly:*
The threads are very small and probably won't hold. I used a soldering iron to carefully heat a screw and seat it inside the plastic.
Place the module power wire along the groove first, then insert the module.
There is a 0.3mm tolerance between the base pegs and the case insert. This is to account for both printed sides, so it may be a tight fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
