Magnetic Light Filter Case - 1.25"

Light Filter Case for 1.25" Filters As part of my ongoing effort to create a collection of 3d printed astronomy accessories, I've gone ahead and created a light filter case. It's a simple design that holds 7 filters, modeled to make it easy to grab filters without getting your finger on the glass. The lid is held in place using a set of magnets. The whole assembly is less than an inch thick and 5 inches squared, so it's fairly compact and portable. The only hardware required is 8 3mmx6mm magnets. The tolerances for the magnet holes are very tight by design, so you may need a rubber mallet to get them seated, once in though - you don't even need glue to hold them in place. PETG recommended - but PLA will work if you're not worried too much about drop protection Recommended Print Settings Outer Walls: 6 Infill 25% gyroid