Magnetic magic Fidget toy

Printing Guidelines: Layer Height: Use 0.2mm for optimal results. Infill: Any percentage works fine. Steps to Follow: File: Fidget_Switch Pause printing just before the hole closes. Insert a magnet, then resume. File: Fidget_Bot Pause printing as the large hole with a square opening starts to close. Insert the completed Fidget_Switch (knob facing downward). Resume printing. Release the switch by pressing it downward. File: Fidget_Top Optionally pause a few layers in for a color change. Pause again after the small hole seals. Insert a magnet in the opposite orientation of the previous one (ensuring repelling polarity), then resume. Assembly: Attach the top piece to the bottom using glue. Enjoy your completed project! Key Notes: Ensure the magnets repel each other. Only one configuration works. Adding a small cube next to the main part can help with nozzle priming after pauses (manually feed filament for color changes). Magnets used: 5x5x5mm. A modifiable file is available for size adjustments.