Thingiverse
Magnetic Mount for Echo Dot Gen 3
by biggie_ticat
9
Downloads
1
Likes
0
Makes
Remix of MrFreakMan87's Echo Dot Gen 3 wall mount.
Uses eight 8x3mm magnets (available in Canada here: https://www.amazon.ca/dp/B0895MFWYX/?coliid=I1MXDBB3IW1XWZ&colid=1TK1N7EHOHLOZ&psc=1&ref_=lv_ov_lig_dp_it)
Removed the watermark from the original.
Magnets press in with a little force. Haven't had any fall out yet. Sticks well to a metal door or sheet steel. Seems to slide down a bit under the weight of the Dot on a glossy surface like a refrigerator.
I printed mine on its back to ensure consistency for the magnet holes. You might be able to get away from using supports if you were to print it standing up.
Used 3D Honeycomb for infill pattern. 25% may have been overkill, but again, wanted to ensure strength of part for pressing the magnets in.
Printed on Prusa Mini using textured spring steel sheet.
Uses eight 8x3mm magnets (available in Canada here: https://www.amazon.ca/dp/B0895MFWYX/?coliid=I1MXDBB3IW1XWZ&colid=1TK1N7EHOHLOZ&psc=1&ref_=lv_ov_lig_dp_it)
Removed the watermark from the original.
Magnets press in with a little force. Haven't had any fall out yet. Sticks well to a metal door or sheet steel. Seems to slide down a bit under the weight of the Dot on a glossy surface like a refrigerator.
I printed mine on its back to ensure consistency for the magnet holes. You might be able to get away from using supports if you were to print it standing up.
Used 3D Honeycomb for infill pattern. 25% may have been overkill, but again, wanted to ensure strength of part for pressing the magnets in.
Printed on Prusa Mini using textured spring steel sheet.
biggie_ticat also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
