Magnetic PC Controller Stand

I've been using a controller stand that I found online and printed awhile ago, but it was big and bulky and was a bit of an eyesore. So I decided to make my own and attempted to make a model involving magnets. This utilizes the rare earth magnets typically found at a hardware store that measure approx. 8mm diameter and 2mm thickness. Be sure to pause the prints to embed the magnets. I made the magnet holes square so the model could be printed on the side without supports. The magnets on their own will not hold up the stand with a controller hence the lip that adds some support on top and the magnets more so help hold it in place.