Magnetic plectrum holder – 3D printable model from MakerWorld

MakerWorld

Music

Magnetic plectrum holder

by Mark_McQ · Music

9 Downloads

13 Likes

1 Makes

Go to Model

This is a magnetic pick holder designed to stick to the front of any amp with a metal faceplate. It holds 7 picks. Multiple STL files are included with slots going from 0.6mm up to 1.2mm. A sizing gauge is also included which can be printed to help determine the best slot size to use for your picks. It starts at 0.6mm on the side with the 2 protruding chamfers, up to 1.2mm on the flat side. The slots go up by 0.05mm. Both the gauge and the holders should be printed on their sides with the slots aligned vertically. 2 x 10mm round magnets are required, 3mm thick.

guitar plectrum guitar pick fender gibson esp ltd schecter ibanez washburn dean stratocaster telecaster rg sg les paul pick holder plectrum holder

Category

Music

Source

MakerWorld

Published

05.03.2025

Updated

30.04.2026

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format

STL

Material

PLA

Post-processing

Hardware

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

Mark_McQ also publishes on

43 additional models across 3 more platforms

♥ 1,296 ↓ 6,323 ⚒ 15

♥ 129 ↓ 1,718

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL