Magnetic Push Pin

This is a push pin that has a hollow base in order to fit a 6 mm diameter x 3 mm height magnet. I made the magnet completely covered on both sides so that the magnet can't slip out while using it. These aren't the strongest push pins since the magnets aren't that big but they are strong enough to hold papers on fridges or whiteboards.

Printing: Print on the flat face of the round magnet. All you have to do while printing is pause the print right before the hollow space is going to be filled (I used Bambu Studio and I added a pause at layer 17) so that you can place the magnet inside and then continue the print. No supports needed for this print.

These are the magnets I used: https://a.co/d/3e1GsM2