Magnetic storm, vase.

Magnetic stormIntroIt wasn't intentional that this vase would be two versions, since the bottom and top was changed quite a bit i thought they both would have their own separate models. I was skeptical at first of the silver silk PLA but it actually turned out good!The main difference from Solar storm is the bottom and top, especially the top have no sharp long edges.If you like this one check out the Solar storm vase here:https://makerworld.com/en/models/56867Will it hold water?You can seal the bottom with wood glue, make sure it gets into the corners too and let it dry can take up to 48 hrs for the corners to get dry. (Get the right kind of glue, here in Sweden It's marked as outdoor that one is water resistant) Printed infoCreated in Blender.Printed with Bambu lab X1C, 0.4mm nozzle, 0.6mm line width, 0.2mm line height, vase mode.Filament used: "eSUN eSUN Metal Silk PLA - Silver"~235mm tall, little over 3½ hr print time.