Thingiverse
Magnetic Tray
door Norrad01
0
Downloads
0
Likes
0
Makes
I designed this tray to sit on top of my laser to hold material clips. The magnets were added to keep the trays from constantly being knocked off.
One tray has a tab slot on the front to hold an ID label. The magnets I used are 5x3mm and fit in snuggly with enough stick-out to make contact with the surface they are sitting on.
Tray measurements are 75x75x25mm.
Printed at 0.3 resolution with no supports and 100% infill.
One tray has a tab slot on the front to hold an ID label. The magnets I used are 5x3mm and fit in snuggly with enough stick-out to make contact with the surface they are sitting on.
Tray measurements are 75x75x25mm.
Printed at 0.3 resolution with no supports and 100% infill.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
