Thingiverse
Magnetic X-Carriage
von Xs4eyes
2
Downloads
2
Likes
0
Makes
X-Carriage with magnet for additions. It uses a very strong magnet -amazon link.
https://www.amazon.com/gp/product/B01MRT31RM/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
This is an 88lb magnet, it was too strong so I had to put a 2mm of plastic in between so I am able to remove it.
There are three locating pegs for easy alignment. The holes in the ends are for limit switch (end stop) or possibly other things in the future, maybe touch sensor?
The adapters will need the metal washer also included in the magnet kit.
Right now I only have made a direct drive adapter.
This is very much a work in progress, ideas are welcome.
EDIT: Been using this for a while now, I have no complaints. Holds strong, but I can pop it off for easy maintenance.
https://www.amazon.com/gp/product/B01MRT31RM/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
This is an 88lb magnet, it was too strong so I had to put a 2mm of plastic in between so I am able to remove it.
There are three locating pegs for easy alignment. The holes in the ends are for limit switch (end stop) or possibly other things in the future, maybe touch sensor?
The adapters will need the metal washer also included in the magnet kit.
Right now I only have made a direct drive adapter.
This is very much a work in progress, ideas are welcome.
EDIT: Been using this for a while now, I have no complaints. Holds strong, but I can pop it off for easy maintenance.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
