Magnetmotor

with this kit, you can built your own Magnetmotor.
The Rotor holds 24 Magnets à 3 Rows (72 Magnets 8mm dia. 5mm hight).
Each Row has a 10 degree offset to the next Row.
The Bores for the Magnets are angled 30 degrees.

The Stator holds also 24 Magnets á 3 Rows (same amount, same size as above).
No offset of Rows. Also 30 degrees angled.

Rotor to Stator Gap: 4mm

You need two bearings (inner dia.: 10mm, outer dia.: 26mm, hight: 8mm), wich can pressed into the Rotor Support. You also need 20 Screws with plastic thread (3 x 12mm) and 144 Magnets 8mm x 5mm round N48, poles on round faces. You have to print 2 pieces of "Lagerbock.stl" and 3 pieces of "Lagerung_Stator.st".

On this Modell you can slide the Stator over the Rotor. Each bore on the Stator has a service bore, which allows you to pry out the magnets to try different patterns.

Sorry, I haven´t found a pattern which works, but with this model you have the ability to make your own research.

If someone found the ri