Magnetospeed Adapter Wedge

One of my barrels is tapered enough that my Magnetospeed chronograph doesn't like the offset between the sensors. I drew up this series of wedges to put in between the clamps to fix the offset. I printed them vertically thick end down.

Note: on Cura I went into the jerk settings and cut it in half down to 4 (units? don't remember) thinking it would help if the build plate jerk made it wobble and screw up the top.

Supports in the slots.(to break the supports out I just squeezed in onto the existing magnetospeed spacer.

PETG for high heat resistance around the barrel

Version 5-8 get less of a wedge, smaller angle as you go up in number. v5 has a larger angle than v8.