Thingiverse
Magpie Temp & Bridge Tower
von ized3D
0
Downloads
1
Likes
0
Makes
A remix for my own needs based on Tronnics blank temp tower. PETG 260-220C, PLA 240-200C. Warmest in the bottom and cooling off the higher you go, in 5C increments.
I've adapted for .25 and .6 nozzles and the layer heights I use most. YMMV. Settings can be imported from the projects. Gcodes are valid for Prusa MK3S+, made in PrusaSlicer v2.6.0.
BEWARE that these settings are _only_ tested in my specific Prusa MK3S+printers, no other printers, settings or setups are tested.
I've adapted for .25 and .6 nozzles and the layer heights I use most. YMMV. Settings can be imported from the projects. Gcodes are valid for Prusa MK3S+, made in PrusaSlicer v2.6.0.
BEWARE that these settings are _only_ tested in my specific Prusa MK3S+printers, no other printers, settings or setups are tested.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
