MakerWorld
Gadgets
Go to Model
MagSafe Charging Stand
412
Downloads
92
Likes
272
Makes
iPhone MagSafe Dock No supports needed Single part print Compatible with Apple MagSafe Charger Slot in and snap into place, ready to charge! This will be tight initially, but it will fit! This requires no glue or tape to hold in place but (However the more you remove it and put it back the looser it will get) Opening at the back to allow you to push the puck out to remove it Handy cable routing underneath to keep cable in place Sits your iPhone at 55°, perfect for watching movies or standby mode at a desk or nightstand Supports horizontal or vertical MagSafe charging Also works in charging AirPods (AirPods Pro 2 & AirPods 3rd Gen) Updates: New print profiles 20mm taller version of the dock if you prefer your phone closer (Available in Fine and Ultra Fine layer heights)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
