Thingiverse
magsafe holder/protector/cover
von Nomin_207
1
Downloads
3
Likes
0
Makes
Simple magsafe charger holder/cover/protector.
!Important!
The cover was only tested on my charger, may not fit your charger. Check outer diameter of your charger and resize if needed.
Outer diameter of holder : 58,5 mm
Inner diameter of holder : 56,5 mm
!Important!
The cover was only tested on my charger, may not fit your charger. Check outer diameter of your charger and resize if needed.
Outer diameter of holder : 58,5 mm
Inner diameter of holder : 56,5 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
