MagSafe mount / charger

MagSafe mount / adapter for auto or anywhere really. Standard 17mm ball and socket. Can mix and match with other mounts that use the same size ball. This mount is specifically built to house the magnetic charging pucks I found on Amazon here:https://a.co/d/iCmoGBe - At the time of this writing are $13.99 USD for a two pack. I chose this specific puck as it allows me to remove the USB cable and use it strictly as a mount if I need to. I originally printed mine in PLA, but it ended up warping in the heat of the car, I switched to PETG, and so far so good. Make sure you remove all the straggler strings from the supports. I used a little sand paper to make sure I got the adapter nice and smooth for the puck to snap into. Plastic on plastic is kinda slippery. The joint swiveled too easily for my liking. To prevent this you could put in a thin .5 - 1mm thick rubber washer at the base of the ball socket, or do what I did, and just cut two pieces of duct tap and layer them on top of each other