Thingiverse
Magsafe Wallet
by Tree-Rex
1
Downloads
4
Likes
0
Makes
Here is s small printable Magsafe Wallet which can hold up to 3 credit cards.
Settings I used:
PLA Filament, 210°C Nozzle, 55°C Bed
40mm/s print speed, tree support
I printed it laying on the long, thin side and put support blockers on the inside so only the hard to print overhang has support and I dont have to struggle removing Support from the inside. Its still kind of hard to print and I couldnt quiet get it perfectly.
NOTE! As far as I can tell this does NOT work properly with the Pro iPhone models (Pro Max DOES work) and the iPhone 16 and newer because the camera bump is slightly in the way.
But should be a somewhat easy fix by just moving the magnets on the wallet a little higher if you know how to edit STL files.
Enjoy!
Settings I used:
PLA Filament, 210°C Nozzle, 55°C Bed
40mm/s print speed, tree support
I printed it laying on the long, thin side and put support blockers on the inside so only the hard to print overhang has support and I dont have to struggle removing Support from the inside. Its still kind of hard to print and I couldnt quiet get it perfectly.
NOTE! As far as I can tell this does NOT work properly with the Pro iPhone models (Pro Max DOES work) and the iPhone 16 and newer because the camera bump is slightly in the way.
But should be a somewhat easy fix by just moving the magnets on the wallet a little higher if you know how to edit STL files.
Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!