MakerWorld
Electronics
Go to Model
MagWLED Case
21
Downloads
10
Likes
11
Makes
The cases online currently were too big and did not fit the footprint of the MagWLED control board. Here is a slim case with no inserts needed. Uses M3x5m screws threaded into the plastic to hold the lid on. It also has reliefs on the back/bottom for 4-10mm x 3mm magnets to mount this to anything metal and hold the case up. The hole on the side fits a 6.8 mm button to control inputs through WLED. This is a snug fit and works great.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
