Mailbox Outgoing Mail Side Pocket (Parametric)

Here is a simple model to add an Outgoing Mail slot to your wall mounted mailbox. The model is parametric, so you can adjust it to fit your particular mailbox but this should fit most standard wall mounted mailboxes (I tested in HomeDepot). The width of the slot is fixed for standard envelopes and not adjustable because I couldn't figure out how to auto scale the honeycomb pattern. If there are a lot of interest in wider slots, I may publish a version that doesn't include the honeycomb pattern, which can be made fully parametric. It prints fast and uses relatively small amount of filament. The label on the front clip is editable in the Bambu Studio slicer so you can put your name or house number of it if you prefer.