Makebase MKS PI and TS-35 Case

This is a single case for the MKS PI and the TS-35 display running Klipper
from MakerBase. This case combines the MKS PI board and the display into a
single module.

Support material is not required to print the 4 required parts. An infill of
20% is recommended. For the CPUBoardTopPlateVertical, an 25% infill,
6 bottom layers, 6 top layers and 3 vertical layers are recommended. This
part needs to be sturdy.

You'll need the following hardware to assemble it:

- Four M5 x 10 mm screws

- Two M5 T-nuts

- Two M5 nuts

- Four M3 x 15 mm screws

- Four M2.5 x 10 mm screws

- Optionally a 30 mm x 8 mm fan

Some of the screws can be replaced with some glue or may be substituted. Do
not overtighten the screws.

Make sure that the connector of the screen is on your left when the display is
set at its final position. This will ensure that the content of the display is
upright.

The four printed parts should be assembled in this order:

1) The ScreenBackPlate an