Thingiverse
MakeHackVoid Toilet Roll Holder
door devdsp
17
Downloads
14
Likes
0
Makes
The sprung plastic part of the toilet roll holder was broken so I pulled the spring out designed this part and printed it off on our rostock.
Designed to fit a120mm span. The spring is 20mm x 60mm.
If I was going to print it again I'd combine the long shaft with one of the pegs but it works fine as is.
Designed to fit a120mm span. The spring is 20mm x 60mm.
If I was going to print it again I'd combine the long shaft with one of the pegs but it works fine as is.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!