Thingiverse
Maker Coin Benchmark Tester
por HappyGilmore
9
Descargas
3
Likes
0
Makes
This is a Benchmark test coin that can check tolerances for individual filaments.
The coin allows you to:
*Check tolerance for M5, M3 nut, M5/4/3/2 threads
*Check single extrusion width
*Check 1mm Wall width
*Check bridging capabilities
*Check support adhesion
*Make side by side comparison using the joints on the outside Diameter
*Locks together with other coins when stacked
* has enough surface area around circumference to add sticky label.
The coin allows you to:
*Check tolerance for M5, M3 nut, M5/4/3/2 threads
*Check single extrusion width
*Check 1mm Wall width
*Check bridging capabilities
*Check support adhesion
*Make side by side comparison using the joints on the outside Diameter
*Locks together with other coins when stacked
* has enough surface area around circumference to add sticky label.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
