Maker Select v2 LCD Mount

Allows the Maker Select v2 LCD board to be mounted on the bottom right side of the Maker Select frame, or to sit (freestanding) on a desktop.


**Assembly**
The face plate mounts to the LCD board and the base optionally bolts to the MS frame using 2 or 4 M3 screws. There are 3 pairs of holes to provide a few height options. (Since the frame screws are structurally critical, it may be advisable to use only the top two, allowing at least the bottom two to remain fully tightened without the layer of PLA under them.)

The face plate slides into the top of the base and is pretty stable as-is, but could be glued in place. Openings in the base *should* allow access to the LCD board screw heads (the bottom screws may be close). There is also a small cutout in the back to allow the ribbon cable through if sitting flush on a desktop.

The LCD can then be connected to the control board using an extended female-to-female 10 pin (2.54mm pitch) IDC ribbon cable.