Makerbot Method X spare extruder holder

We got two Makerbot Method X and a couple of extruders with it. I needed a holder for these close to the printer. After a couple of iterations i had these holders. The holder can contain two extruders and also the tools from the printer.

I printed these with ABS, no supports needet.
A pre-sliced file is attached. Its sliced for ABS and a little bit of SR30 for the raft.

If you want, you can print these in pretty much any other Material, it doesn't matter.

You need to print all the parts once and you also need a small piece of filament (~10cm) as a hinge pin. Just melt one end, stick it through the hinge, cut it a bit longer (~5mm) than the model and melt the other side. The material doesn't matter, i used a piece of PLA.