Thingiverse
Makerbot Mini+ Large Spool Holder
von Mohnki
7
Downloads
4
Likes
0
Makes
Large Spool Holder for the Makerbot Replicator Mini+
I could not find a holder that was snug enough on the back of the Mini that I was happy with so I designed this one.
It is printable on the Mini+ for the Mini+ but I am sure it will fit on other models as well.
The Filament tube holder is from [Thor3D](https://www.thingiverse.com/Thor3D/about) and is available [here](https://www.thingiverse.com/thing:406857/#files)
V2 uploaded. I found that the initial bracket was a little wide and so the Filament holder didn't have enough space. Version 2 is narrower and requires supports. I found that the supports do not print correctly on the Makerbot Mini + with out the raft. Both parts print at the same time.
I could not find a holder that was snug enough on the back of the Mini that I was happy with so I designed this one.
It is printable on the Mini+ for the Mini+ but I am sure it will fit on other models as well.
The Filament tube holder is from [Thor3D](https://www.thingiverse.com/Thor3D/about) and is available [here](https://www.thingiverse.com/thing:406857/#files)
V2 uploaded. I found that the initial bracket was a little wide and so the Filament holder didn't have enough space. Version 2 is narrower and requires supports. I found that the supports do not print correctly on the Makerbot Mini + with out the raft. Both parts print at the same time.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!