Makerbot Replicator+ Build Plate Mount

I had some leftover glass shelving from a DVD shelf that was about the size of the Makerbot Replicator+ build plate. I thought this could make a good build plate.

I would not recommend this unless you are very familiar with the printer.

The mounts are divided into various pieces that can be glued onto the glass plate. There are a few guides nubs to help with the alignment.

Since the glass and the mount, was slightly higher than the Makerbot build plate, it required a z-offset. The z-offset sits on the top right side of the Makerbot build plate upper block, because the z-axis switch sits on that side. The offset for the glass plate was about 1mm.

To level off the build plate, the front mounts are taller about 2mm.


Update:
Fixed V01 pieces d, g, and h.