Thingiverse

Makergadgets Innovator Wire Plug

by jonspaceharper

5 Downloads

1 Likes

0 Makes

This is a wire management hole and PTFE passthru for the Makergadgets Innovator enclosure. The plug fits the roughly a 1 3/8" in the back left of the enclosure, sealing it off but letting wires through.

Two pneumatic connectors screw in each side with a PTFE coupler between them. This lets you keep dryboxes with heat-intolerant materials stay outside of the enclosure, along with your electronics.

This needs to be printed in TPU for the flexible flaps to work. TPU is also heat-tolerant enough for inside of the enclosure.

Assembly requires 2 M3 x 16mm screws and 2 M3 nuts.

3d printer enclosure enclosure makergadgets PTFE connector TPU wire management 3d printer enclosure enclosure makergadgets PTFE connector TPU wire management

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format