MakerGear M2 Pen Holder

This is a simple pen / pencil holder for the MakerGear M2 single and dual extruder setups. It bolts on with just one screw, which I used the longest screw from the cooling fan mount.

Use scaffolding/supports at your own discretion.

To mount this holder you must remove the cooling fans on the extruders. If you may remount the fans for high detailed and faster drawing speeds but that's up to you. You may need to move around a screw or two to get it to mount correctly.

If your pen does not fit perfectly, just use a lighter to heat up the pen holding clips and expanded them to where you need it to be.

I didn't put a lot of time into this, just some quick editing of an existing pen holder. This is the original thing: https://www.thingiverse.com/thing:70891.