Thingiverse
Makerknife TPU Holster
door jocke2018
5
Downloads
5
Likes
0
Makes
This is my version of a Belt-Holster for Giaco's Makerknife.
After a while of everyday carriage i struggled with the attached Belt Clip an desided to remove it and make this Holster to carrie the makerknife without the clip.
The Holster is designed slip on a 38mm Belt. I use it on the right hand side and pull it out with the index finger.
At the bottom of the Holster there is a notch that prevent the blade to slip down in the holster and keep the ring at top. Inside are 2 bulges that prevent the Makerknife from accidentally slipping out.
For me best printing without Infill and only 2 outer-shells.
The plug on the intake is to Stabilize while printing and musst be cut-out after print
After a while of everyday carriage i struggled with the attached Belt Clip an desided to remove it and make this Holster to carrie the makerknife without the clip.
The Holster is designed slip on a 38mm Belt. I use it on the right hand side and pull it out with the index finger.
At the bottom of the Holster there is a notch that prevent the blade to slip down in the holster and keep the ring at top. Inside are 2 bulges that prevent the Makerknife from accidentally slipping out.
For me best printing without Infill and only 2 outer-shells.
The plug on the intake is to Stabilize while printing and musst be cut-out after print
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
