Makita DC18SD

Flush mounting for Makita DC18SD charger. One of the sides has pin holes that are not straight up and down, so I decided to cant the screwholes relative to the mount, so you end up with the smallest possible mount, but also have vertical hole alignment.

The hole clearance I chose is around "eh this will not come off unless you REALLY pull on it". I did this in my heated ABS enclosure, and haven't tested it with PLA or PETG yet, so not sure if the near interference fit I specified will work out well.


I have no idea why everyone prints Makita chargers at an angle.

I also mounted Makita dual chargers with the same designs, but due to someone selling them commercially, I'll only release those files if you ask, rather than publishing them.