Makita Flame Light

Flame light base and parts list to convert 120V Edison screw bulb to Makita Battery pack.

I recommend setting the Buck converter board to 11V for light longevity. A Battery protection Board must be used to protect the battery from over discharge. This setup is rated at 2 amps max (Makita battery protection board), the light draws 200mA at the battery. To assemble, I just shrink wrapped the buck converter board to the battery protection board with a piece of plastic between them (as shown, electrical tap can be used but it might smell like a vinyl swimming pool in summer when it gets warm) and shoved them down the centre of the light.The top cap is glued on but it is also optional.

Parts list:

Flame light: https://www.amazon.ca/gp/product/B07GKXSDNR
Buck converter board, LM2596: https://www.amazon.ca/dp/B07JNQFV7F
battery protection board, GM00001029: https://www.ereplacementparts.com/pcb-p-80464.html
Makita terminal block, GM00001116: https://www.amazon.com