Malahit DSP SDR clone case

This is a case for the Malahit DSP clone.
Look carefully at the PCB photo, this PCB is the 4 layer version with a shield on the receiver section. The tuning knob is at the bottom.

Please do not attempt to modify your Malahit PCB if you don't think you have the skill to do so. Ask another person you may know to help.

The case has been designed for what I had in mind. It has room for a 6000mA battery.

A USB panel extension cable was purchased from Aliexpress. A 3.5mm stereo socket and a momentary press button.

The encoders were removed and replaced with headers, The on board 3.5mm socket was removed and replaced by another header. Two wires were soldered across the power switch to another header.

I made some PCB to common up the wiring for the encoders, power switch and 3.5mm audio socket.


I used a Prusa MRK3s

The filament I used for the case was PetG, the knobs are printed in TPU.
The front is printed face down, some support is needed for the holes