Thingiverse
Mamaroo - Adjustment Linkages
3
Téléchargements
1
Likes
0
Makes
I printed these parts with PLA;
Bed Temp: 200degC
Nozzle Temp: 65degC
Speed: 40 mm/s
infill: 100% (Because I deserve it)
The washers are meant for the two screws used to link the rubber pad to the center linkage. Use the screws from each respective hole, to determine which of the 2 washer sizes is appropriate to keeping the linkage attached to each end.
If there are fitment issues, try decreasing the through hole diameter of the rubber boot side. This would reduce the change of the linkage slipping over the receiver on the rubber boot.
Bed Temp: 200degC
Nozzle Temp: 65degC
Speed: 40 mm/s
infill: 100% (Because I deserve it)
The washers are meant for the two screws used to link the rubber pad to the center linkage. Use the screws from each respective hole, to determine which of the 2 washer sizes is appropriate to keeping the linkage attached to each end.
If there are fitment issues, try decreasing the through hole diameter of the rubber boot side. This would reduce the change of the linkage slipping over the receiver on the rubber boot.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
