Mandalorian

It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  You may print at higher layer heights below the Min Depth of 0.56mm  The Max Depth is 2.2mm and the Actual Depth is 2.2mm PLA Elegoo+ Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA Devil Design Light Brown Transmission Distance: 1.6 PLA Elegoo + Gray Transmission Distance: 3 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 5 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Grey At layer #12 (1.04mm) swap to Light Brown At layer #13 (1.12mm) swap to Gray At layer #17 (1.44mm) swap to Jade White for the rest.