Thingiverse
Manfrotto MKCOMPACTLT Stem
door Bekar
4
Downloads
6
Likes
0
Makes
I purchased a small, lightweight tripod from Manfrotto (MKCOMPACTLT), but the default mount wouldn't simply take the tripod head I primarily use with my camera (comes with 1/4-20 head attached to the stem).
In order to use my tripod head, I needed the larger thread (3/8-16) so I designed a stem to replace the default one that would take an appropriately sized bolt from the hardware store.
This piece is designed for a 3" bolt, but can be shortened in most slicers without concern (just make sure to leave about 1/4-3/8" above the surface; most bolt measurements don't include the head, so make this piece the same published length of the bolt as the head is recessed).
In order to use my tripod head, I needed the larger thread (3/8-16) so I designed a stem to replace the default one that would take an appropriately sized bolt from the hardware store.
This piece is designed for a 3" bolt, but can be shortened in most slicers without concern (just make sure to leave about 1/4-3/8" above the surface; most bolt measurements don't include the head, so make this piece the same published length of the bolt as the head is recessed).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
