Thingiverse
Manfrotto quick release + phone holder
von buildbysammie
1
Downloads
3
Likes
0
Makes
Manfrotto quick release + phone holder.
The phone holder exist of 4 parts, a block to attach to the Manfrotto tripod, a slider to slide on the block and 2 parts for the phone holder (fits sizes up to 95 mm). The block and the slider can be used for other tools or holders by creating your own attachment which you can glue to the slider. Your own attachment will need to fit on the slider, a picture of the dimensions (in mm) is added so you won't have to rely on measurements of prints.
The phone older isn't fully finished, it now holds the phone with a rubber band so the phone doesn't slide out. The block and slider are finished.
Hope you like it!
(P.S. i see the irony of creating a quick release on to a quick release)
The phone holder exist of 4 parts, a block to attach to the Manfrotto tripod, a slider to slide on the block and 2 parts for the phone holder (fits sizes up to 95 mm). The block and the slider can be used for other tools or holders by creating your own attachment which you can glue to the slider. Your own attachment will need to fit on the slider, a picture of the dimensions (in mm) is added so you won't have to rely on measurements of prints.
The phone older isn't fully finished, it now holds the phone with a rubber band so the phone doesn't slide out. The block and slider are finished.
Hope you like it!
(P.S. i see the irony of creating a quick release on to a quick release)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
