Manfrotto Tripod replacement lever

Many Manfrotto tripods use a plastic swivel lever to tighten the leg clamp. This often can break. This design is a replacement for that lever. You should check to see that your levers indeed look like this one.

The print should be made in the orientation shown and does require supports from the bed that are easily broken away. I also used a skirt. Infill should be 100% for strength. Print quality was normal at 0.2 layer height. I used PLA and have worked the part a number of times with no signs of breaking. But I may reprint this part again in PETG if I plan to use the tripod in the hot summer sun.