Slicer Discord
Mantis HT3  – 3D-Druckmodell von GrabCAD GrabCAD
STEP / IGES, STL

Mantis HT3

224 Downloads
44 Likes
0 Makes
Zum Modell
This is an experimental Ship Created by the Sith Empire (Kuat Drive Yards to later be know as Corellian Engineering Corporation CEC). You will notice that the ship has an R2 unit and the Jedi insignia on the back end of the ship. This is stolen technology from the Sith Empire and modified by the Jedi Order to be used against the Sith on Hoth. It is going through trials on Tatooine for hot dry environments. This is a three Crew vehicle and can carry 2+ passengers. It has the ability to hover above the ground for high speed travel and land on the ground for slow maneuvering on level terrain. This is just something I felt like would be fun, so I created this model around the short story above. It is not actual Jedi folklore; But it could be. SO pay attention Disney.....
Kategorie
STEP / IGES, STL
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL, STEP
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen